Industry News

UV LED curing light replace the mercury light

With the improvement of UVLED brightness and technology, as well as the general promotion of environmental awareness in recent years, curing process equipment to speed up the introduction of UVLED, UVLED replacement UV mercury lamp is expected to grow at a higher rate of demand.
Traditionally, the curing process equipment used is UV mercury lamp, namely UV mercury lamp, the lamp of life only for 500 to 1000 hours, and time use before first preheating, the effective use of longer time less than 500 hours. But traditional mercury lights will produce a lot of heat and infrared, will damage the coating, it needs to use far distance and reduce efficiency in the use of; and a lot of heat and infrared lead to high heat, need to match the cooling system and air conditioning equipment, coupled with a large volume of device, large energy consumption, short service life, mercury, and produce ozone to wait, these are the disadvantages of conventional UV curing mercury lamp.
Phase compared to UV mercury lamp, UVLED with higher efficiency, stable energy, low power consumption, long life and in line with the characteristics of environmental protection, in recent years, more and more manufacturers began to requirements in curing equipment for UVLED is substituted for the UV mercury lamp, such as the apple has asked for the coordination of the manufacturers should be if it has curing machine equipment, required to fully convert UVLED use, thus including Chen Hong and other industry, has completed the conversion of the products.
It is reported that the current UVLED has been put into the assessment of which. However, when the curing equipment in favor of a UVLED, lighting energy, efficiency and the traditional UV mercury lamp vary, in consideration of adaptation and yield factors, related to ink, glue formula must be adjusted. Due to the use of UVLED has the advantage of environmental protection. Therefore, it has replaced the traditional UV mercury lamp has been used for warming trend, in the Japanese market, in addition to see such as printing and other industries have been more than a jig for UVLED after use, with industrial process using the import increase, estimated in recent years in the mainland, Taiwan can also see the emergence of the demand for better development.
Hits:  UpdateTime:2016-04-25 15:09:27  【Printing】  【Close

News

Contact Us

Address:Address:Office/ Factory address: 2/F, Tower B, Sanhe international science and technology Building, Lai Wu Shan New Village ,Da Lang Road,Long Hua District, ShenZhen, Guang Dong Province, China.
Zip:518109  
Tel:+86-755- 27381112          
Fax:+86-755-22718753  
E-mail:info@height-led.com  
Mobiled Phone:
    Mandi:   +86-18924589491
   Jerry:     +86-15112366475 
    Duke:     +86-13192028497
 
Skype:
   HTLD led uv curing-Mandi
   HTLD led uv curing-Jerry  
   HTLD led uv curing-Duke    
Website:www.height-led.com/en