Company News

lab recommend UV LED equipment

Recently we received a research unit of the University of UVLED curing equipment consulting, I think I need to write an article and share with you, the correct guidance of UV curing light source selection recommendations.
One. Spectrum
At present, due to the development of light cured, there are many applications, such as surface curing, visible light curing etc., there are some UVA UVB or enhanced visible light bulbs, UVLED curing machine advanced, generally with different spectrum without any hardware changes, it can greatly increase the flexibility of research and development.
Two. Energy
For UVLED curing machine: UV LED energy (mJ/cm2) = UV intensity (mW/cm2) * exposure time (S); therefore, the UVLED intensity and exposure time of precise control,  it is able to accurately control the UV LED energy. On the exposure time control, we advanced UVLED curing machine, built-in computer microprocessor, can set the exposure time and a variety of modes. To control the strength of UVLED, we use the computer to adjust the percentage of control, at present can do 0% - 100%. Because we can do LED technology that is bright.
Three. Intensity distribution
UVLED curing machine UV intensity is very uniform, almost no change in the intensity of UV. With GOOD microprocessor full-featured curing machine, with high-tech LED and high-tech optical lens, the intensity range in the 1000mw/cm2-8600mw/cm2. do not choose some of the so-called "uniform" UV LED curing machine without data.
Four. Safety and temperature
Advanced UV LED curing machine with lock safety, automatic shutdown exposure shutter, to protect user security. Some other designs, including the tip of the heat sink technology and the computer microprocessor function, effectively control the temperature rise. This requires special attention, the traditional temperature control lamp is no good source, will cause serious hidden trouble of bulb burst.
Five. Stability
This point of the traditional process is difficult to directly prove that the accumulation of industrial experience is generally. The general laboratory is usually not equipped with a machine, a stable source of light is very seriously affected the progress of the relevant test. And we have a rigorous test report of the Japanese lab, the test data is far higher than the international standard.
Hits:  UpdateTime:2016-12-05 17:03:48  【Printing】  【Close

News

Contact Us

Address:Address:Office/ Factory address: 2/F, Tower B, Sanhe international science and technology Building, Lai Wu Shan New Village ,Da Lang Road,Long Hua District, ShenZhen, Guang Dong Province, China.
Zip:518109  
Tel:+86-755- 27381112          
Fax:+86-755-22718753  
E-mail:info@height-led.com  
Mobiled Phone:
    Mandi:   +86-18924589491
   Jerry:     +86-15112366475 
    Duke:     +86-13192028497
 
Skype:
   HTLD led uv curing-Mandi
   HTLD led uv curing-Jerry  
   HTLD led uv curing-Duke    
Website:http://en.height-led.com